![]() ![]() ![]() Control Panel -> User -> Create -> Enter password, username.Create HomeAssistant User on diskstationįirst we need to create a new user on our diskstation:Ĭreate a user which can be used from home assistant to login to your diskstation To turn off the diskstation remotely we need to login via ssh and call the poweroff command. For more details see the integration documentation. The host parameter contains the ip of the diskstation, so it can check if the diskstation is online or not. My configuration looks like this: switch: We just need to supply the mac address of our diskstation in the configuration. It allows to add a switch which sends the packages when it is turned on. This can be done with the Wake on LAN integration. Now we need to send this magic package from Home Assistant. Your device is identified by the mac address. This is NOT the ip-address of your device, this is the broadcast address. Note: For sending a magic package via wakeonlan you can specify an ip: -i ip_addressĭefault: 255.255.255.255 (the limited broadcast address) # Wake up diskstation by using its MAC Address on a Mac you could run following command in the terminal: # Install wakeonlan command via brew Under Power Recovery activate Enable WOL on LanĪfter that you are able to start your Diskstation over the network.Go to Control Panel > Hardware & Power > General.Diskstation configurationįirst we need to enable Wake on Lan on our diskstation: We can use Wake on Lan to turn of the diskstation by a network message. This article describes the configuration steps, necessary for this. I achieved this by controlling the Diskstation via Home Assistant. Also it would be nice if I could turn it off with my "good night"-Switch next to my bed. Another example would be to power on the diskstation to store a Home Assistant Backup and afterwards power it off again. I would like to automatically turn on the Diskstation when I come home, so my Smartphone can backup data. It would turn on at a certain time and power off every night. In the past I configured a "Power schedule" directly within the Diskstation. Therefore it does not need to run all the time. I had a look in the the root/.ssh of OMV and there are already two files with the same id-rsa and id-rsa.I use my Synology Diskstation mainly as a backup device. I am little lost if I need a subfolder in the. The shudown command in the configuration.yaml should then be: "sudo ssh poweroff" This generates apparently two files- a id-rsa and and id-rsa.pubģ login to OMV: ssh (or do I login as root?)Ĥ) cp id-rsa.pub (or is it the id-rsa without the. ![]() I am unsure of where to put these keys on the OMV side and before I go and break something I though I would throw this out there if anyone could correct or refine my steps:ġ) using root account on Rasppi (with Home Assistant) generate RSA Key: ssh-keygen -t rsaĢ) save key to ~/.ssh. Here is where I am a little lost after digging the the OMV and Home Assistant forums, but so far I understand the easiest and best way to achieve this is through generating an RSA key on the Home Assistant Rasppi and transferring that to OMV, thus allowing a "one-liner" shutdown command. Now for how can I integrate a shutdown command by toggling the switch to the "off" position. It wakes up the OMV server and the switch registers the the server is on by the highlighted symbol. In my Home Assistant (installed on a Rasppi) I have figured out how to create a "switch" in the configuration.yaml which sends a WOL signal using the MAC address of my OMV installation I am sure there are some people here have messed around with it but if not the question is independent so the answer for proficient linux users is likely a simple one.for me I am still learning. I am getting a little bit into home automation and have been implementing bit by bit small actions and automations into my Home Assistant interface. ![]()
0 Comments
Leave a Reply. |